This is a short and easy step, then we’re almost done the panties!
If you haven’t already, give the undies a try-on to make sure they don’t need to be taken in or let out at all.
Now, we need to stabilize the leg-line of our panties with some elastic. I’ve found that this gives the most comfortable fit and best finish. However, you may opt to simply turn the edges under and use a twin needle or zig-zag stitch to finish the raw edges of the gusset and sequin front.
I use a zig-zag stitch to apply the elastic to the inside of the garment along the Panties Front & Gusset. This step is why it was important in our last step to make sure that the gusset and sequin fabric overhang the scalloped edge of the lace by about 1/4″. The elastic will now get zig-zag stitched along that edge, then turned under and top stitched in place with a twin needle.
Before you apply the elastic, you may want to snip off any sequins running along the edge of the panties, so that you end up with a 1/4″-3/8″ strip of sequin-free area along the leg line.
The elastic here acts as a stabilizer and prevents these undies from stretching out uncomfortably during wear (or bunching and scrunching, no one needs that). You should only apply the tiniest about of tension. I’m using just a plain old knitted elastic that’s relatively thin and very stretchy.
Once the elastic has been zig-zag stitched onto either side, trim any excess fabric that extends beyond the edge of the elastic.
Turn the elastic under, towards the inside of the garment, and use a twin-needle to top stitch in place. Please make sure you have switched from a zig-zag stitch to a straight stitch, and go slowly over the sequin areas.
I’ve added a video to my YouTube channel that will walk you through these steps in even more detail.
We’re almost done sewing these pretty, sparkly undies already! I’ll post tomorrow about how to finish the waistline with fold over elastic, then we’ll move onto the bra.
No Comments